Methodology

Every number on this site is either sourced or labelled as an estimate. This page explains the difference.

1. Structure before storage

We start with what the garage can carry: ceiling height, joist direction and span, wall type, and the anchor that matches. Manufacturer load ratings are cited from the product manual, not from a retailer's bullet point.

2. Cost models show their inputs

Installed-cost estimates use visible inputs: system, anchors, lumber, labor, and any drywall or paint repair. Our calculator exposes the dimensions so you can replace them with your own measurements. We do not present a single "average cost" as if it were a quote.

3. Product selection

We compare specifications and installation constraints. A product earns a recommendation when it meets a defined constraint: a rack that fits an 8-foot ceiling, a cabinet that clears a car door, or a wall system rated for the weight you plan to hang.

4. What we have not tested

We do not own every product we write about. When a claim comes from the manufacturer or from owner reports, we say so. When we have not tested a unit, we do not imply that we have.

5. Corrections

If a source changes or a reader finds an error, we update the article and the "last updated" date. Emailcontact@garagevertical.com with the page and the correction.

What we do not test

We do not pull a rack to failure or verify every anchor in every wall type. When a number comes from a manual or an owner report, the article says so. When we have not tested a product, we do not imply that we have.